Sand Estimator

Estimate how much sand you need for pavers, play areas, leveling or construction — in cubic yards, tons or bags. Use this sand estimator to work out exactly how much sand your project needs before you order.

Sand Estimator

ft
ft
ft

Free to use • No sign-up needed

Sand compacts when wet. For paver bedding use exactly 1 inch of screeded (not compacted) coarse sand.

How to Use This Calculator

  • Measure the length and width of the area in feet.
  • Enter the depth of sand you need, in inches.
  • Choose your sand type and bag size, if needed.
  • Click Calculate to see how much sand you need in cubic yards, tons or bags.

How Much Sand Do I Need?

The amount of sand you need depends on the area and the depth. For most jobs, measure the length and width of the area in feet, decide the depth in inches, and the calculator above turns those numbers into cubic yards, tons and bags.

As a quick reference, one cubic yard of sand covers about 100 square feet at 3 inches deep, or about 150 square feet at 2 inches deep. A 10-by-10-foot area at 3 inches deep needs about 1 cubic yard. Doubling the depth doubles the amount, so a small change in depth makes a big difference to the total. Always measure the depth you actually need rather than guessing.

Types of Sand and What Each Is For

Not all sand is the same. Using the wrong type can weaken concrete, wash out from under pavers, or feel wrong underfoot.

  • Play sand: Fine, soft and washed. Made for sandboxes and play areas. It is screened to remove sharp bits, and it is usually the most expensive per bag.
  • Masonry sand: Fine sand used for mortar and brick work. It is clean and consistent, which matters when it is mixed with cement.
  • Concrete sand: Coarse sand used as an ingredient in concrete. Its rough grains lock together and give concrete its strength.
  • Paver sand: Fine sand swept into the joints between pavers. Polymeric paver sand hardens when wet and locks pavers in place.
  • Fill sand: Cheap, coarse sand used to fill holes, level ground and build up low spots. It is not clean enough for concrete or play areas.
  • Leveling sand: Fine sand used in a thin layer under pavers and above the gravel base, usually about 1 inch deep.

If you are not sure which type you need, ask your supplier what the sand will be used for. They deal with this question every day and will point you to the right pile.

How Much Does a Cubic Yard of Sand Weigh?

A cubic yard of dry sand weighs roughly 2,600 to 3,000 pounds, depending on the type and how wet it is. Wet sand weighs more, sometimes over 3,000 pounds per cubic yard.

This matters for two reasons. First, delivery: a standard dump truck carries about 10 to 14 cubic yards, which is 13 to 20 tons of sand. Make sure your driveway can take the weight before the truck arrives. Second, bags: a 50-pound bag of sand is about half a cubic foot, so one cubic yard takes roughly 54 bags. Buying by the bag makes sense for a small job. For anything over a cubic yard, bulk delivery is usually far cheaper.

Sand for Pavers: How Much Do You Need?

Paver projects need two kinds of sand. The bedding layer under the pavers is usually about 1 inch of coarse concrete sand or leveling sand, screeded flat over the compacted gravel base. The joint sand goes between the pavers after they are laid, swept in and watered down.

For the bedding layer, one cubic yard covers about 300 square feet at 1 inch deep. For joint sand, a 50-pound bag covers roughly 100 to 200 square feet of pavers depending on the paver size and gap width. Smaller pavers with more joints need more sand. If you are using polymeric sand, follow the bag instructions exactly. Too much water too fast can wash the binder out before it sets.

Common Mistakes to Avoid

  • Using fill sand or play sand in concrete. The wrong sand weakens the mix.
  • Guessing the depth. An extra inch over a large area adds up to a whole extra cubic yard.
  • Forgetting the waste factor. Spills, uneven ground and compaction mean you should order 5 to 10 percent extra.
  • Ordering bags for a big job. Over a cubic yard, bulk sand delivered by truck costs far less per cubic yard than bags.
  • Skipping the call before you dig. If your project involves digging, call 811 first. It is free, and it is the law in most states.

Bottom Line

Pick the right type of sand for the job, measure your area and depth carefully, and add 5 to 10 percent for waste. Use the estimator above to turn your measurements into cubic yards, tons and bags before you order.

Written by the Yard & Bag Editorial Team. Our content is researched and checked against supplier guidance and standard building practice.

Related guides: How Much Sand Do I Need for Pavers?

Frequently Asked Questions

How much sand do I need?

Measure the length and width in feet and the depth in inches. One cubic yard of sand covers about 100 square feet at 3 inches deep, or about 150 square feet at 2 inches deep. A 10-by-10-foot area at 3 inches deep needs about 1 cubic yard. Use the calculator above for the exact number.

How much does a cubic yard of sand weigh?

About 2,600 to 3,000 pounds dry, depending on the type and how wet it is. Wet sand can weigh over 3,000 pounds per cubic yard. A standard dump truck carries about 10 to 14 cubic yards, which is 13 to 20 tons, so make sure your driveway can take the weight before delivery.

What type of sand should I use for pavers?

Use coarse concrete sand for the bedding layer under the pavers, and polymeric sand for the joints between them. Polymeric sand hardens when it gets wet and locks the pavers in place. Do not use play sand or fine masonry sand for a paver base.

How deep should sand be under pavers?

One inch of screeded bedding sand over a 4- to 6-inch compacted gravel base. The sand is only a leveling layer, not the base itself. A thicker sand layer will shift and settle under foot traffic.

How much does sand cost?

Bulk sand usually runs about $25 to $50 per cubic yard delivered, depending on the type and your region. A 50-pound bag costs a few dollars at a garden center. For anything over a cubic yard, bulk delivery is far cheaper per cubic yard than bags.

Scroll to Top